- Transfer files from mac to pc ethernet upgrade#
- Transfer files from mac to pc ethernet pro#
- Transfer files from mac to pc ethernet mac#
Transfer files from mac to pc ethernet pro#
When connecting the Apple 15-inch MacBook Pro (Late 2016) to the MSI GS73VR Stealth Pro directly using a Thunderbolt 3 cable, we accepted adding the new Thunderbolt device in the pop up.
Transfer files from mac to pc ethernet mac#
To demonstrate this, we performed a file transfer between a Mac like the Apple 15-inch MacBook Pro (Late 2016) and the Windows 10 based MSI GS73VR Stealth Pro, both supporting Thunderbolt 3. so backup beforehand by using a locally connected disk should still work fine.The Thunderbolt 3 technology provides a solution to connect two Thunderbolt 3 based PC's using 10Gb (Full Duplex) Ethernet networking. there is always some danger in messing around that you do something that you will regret. I would suggest you get a large USB drive and plug it straight into the computer and directly backup the files. If you don't have a backup of your important files and libraries. Resetting the System Management Controller (SMC) on your Mac - Apple Support How to Reset NVRAM on your Mac - Apple Support
Transfer files from mac to pc ethernet upgrade#
because network issues are not uncommon with upgrade installs. What do you have IPv6 set to in the computers? It should be link-local only.ĭId you do a NVRAM and SMC reset in the computers you upgraded to El Capo. Then check the file copy speed with a single very large file. SMB://10.0.1.1 (replace with the actual IP of the Extreme). mount it in the computer using SMB from Finder, Go, Connect to Server in top menu area. In each computer have you turned on SMB network shares. I am not sure why but Apple have moved the default network to SMB since Mavericks and it does affect the links. It is really important to use SMB protocol now. If that is the case the issue is the computers and network setup. you have run ethernet link between two computers directly, not via the Extreme. I have even tried bypassing the wireless network altogether and connecting the machines directly to each other via ethernet, with wireless networking turned off, and the problem persists.Īm I reading this correctly. I need actual numbers rather than just the description. Open the Activity Monitor and give me an actual speed of the file transfer when it is computer to computer. What mode is the AE running, bridge or router? What modem do you have? Is it also a router? It can help to figure out when the problem started and what was done or changed in the network at the time that could cause it. Any assistance would be greatly appreciated. I have searched dozens of posts but I have yet to find any solution to this issue. Strangely, I can download/ upload files form the internet at normal (fast) speeds it's just computer to computer transfers that are lagging. I know none of the disks are the problem since I've tried various combinations of machines and destination disks, and the problem is still there both in wireless and ethernet transfers. When I try to copy the files to another machine, I get the "preparing to copy" message for about 5 minutes, then the files eventually begin to transfer, but extremely slowly (something like 1MB every 10 seconds.) Sometimes if I let the file transfer continue, it will speed up for a while, but it eventually slows down again. I'm am trying to backup a large iPhoto library which is 290GB. I have even tried bypassing the wireless network altogether and connecting the machines directly to each other via ethernet, with wireless networking turned off, and the problem persists. I am experiencing glacial file transfer speeds between the machines. The New Mac Pro and Mac Mini are running OS X El Capitan and the Older Mac Pro is running Yosemite. I have a new Mac Pro, previous generation 2009 Mac Pro, and a 2012 Mac Mini all operating on an Airport Extreme (latest model, latest firmware) wireless network.